Easy ?T-80 Provozní pokyny stáhnout pdf (Strana 10)

6

Installation - SITING OF THE SHOWER

Isolating

stopvalve

Mains

water

supply

Shower

unit

Mains electric supply

(via double pole switch)

Double

pole

isolating

switch

Separate permanently

connected supply

from consumer unit

Diagrammatic view (not to scale)

SITING OF THE SHOWER

The installation must be in accordance with

Water Regulations/Bylaws - see page 2 for

water specifications

• Ifitisintendedtooperatetheshowerat

pressures above the maximum or below the

minimum stated, contact Customer Service

for advice.

• Ifthestatedflowratesarenotavailable,

it may not be possible to achieve optimum

performance from the unit throughout

the year.

• Duringperiodsofhighambienttemperatures

it may be necessary to select the economy

power setting to achieve your preferred

shower temperature.

Fig.5 shows a typical system layout.

NOTE: The control knobs are an integral part of

the cover. Do not attempt to remove them.

• Liftthecoverfromthebackplateandremove

the trimplate.

• Referto(fig.6) for the correct siting of

the shower. Position the unit where it will

NOT be in direct contact with water from

the showerhead. Position the shower unit

vertically.

• Allowenoughroombetweentheceilingand

the shower to access the cover top screws.

• Markoutentrypointsandroutingofthe

water and electric supplies into the shower.

Fig.5

4

check list

SECTION

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Komentáře k této Příručce

Žádné komentáře